Caring for Your Pressure Washer

Caring for high pressure cleaners in Singapore is discussed in this article. It is important to take good care of pressure washers or cleaners to maintain its performance and efficiency. It is important to always have a clean air filter in the engine. The air filter must be clean in order to effectively prevent dirt, dust and other harmful debris from entering the engine. Every four hours of use, clean the filter. Every 100 hours of use or every three months of use, replace it. Pleated, paper air filters cannot be cleaned without damage so they should be replaced. Foam air filters can be cleaned with hot water and a small amount of dish detergent. When the filter is completely dry, saturate it with new engine oil before reinstalling it. Do not use oil on a foam filter if your model also uses a paper element filter.

It is also critical to clean or replace the fuel filter a few times per year. Follow your pressure washer owner’s manual for specific instructions related to fuel filter cleaning. Note that the location of the fuel filter varies by model so it’s important to consult your owner’s manual. If there is debris clogging the mesh screen inside of the fuel filter, replace it before using the pressure washer again.

The engine oil must be checked regularly or before each use of the pressure cleaner. Prior to each use, check the oil level of the pressure washer. Fresh oil is golden or amber-colored. As it ages, it will darken. Replace the oil if it becomes too dark – or at least every 50 hours of use or once per season.

The water inlet screen/filter must be regularly cleaned. Periodically check the water inlet screen for dirt and debris build-up. Rinse it with water. Allow it to dry thoroughly before returning it to the pressure washer. If you find any damage to the screen, replace it before using the equipment again.

The hose, trigger handle and hose connections must be inspected to maintain high pressure. Before each use, check the hose, trigger handle and hose connections for wear or damage. These pump parts must be repaired or replaced when damaged to achieve hassle free operation.

Prior to storing the pressure washer for winter or the off-season, be sure to add fuel stabilizer to fresh fuel. This will slow damaging build-up in the carburetor. To prevent the water pneumatic pump from freezing in cold regions, create a solution of 50 percent anti-freeze and 50 percent water and run it through the pump. This will keep internal parts lubricated and prevent the pump from cracking.

If the pressure of the water keeps changing, you must check all of the hoses to make sure there are no kinks or blockages. Also check that there is no interruption from the water supply to accommodate the water requirement. It is not advisable to use any kind of detergent in the pressure washer due to the high pressure function. You should only use detergent designed for pressure washers. Pressure washers must be properly stored in a clean, dry place that is well ventilated.

Ying

Leave a Reply

Your email address will not be published. Required fields are marked *